GentooForum.de

Quellcode

Linux version 2.6.11-gentoo-r11 (root@stylistic) (gcc version 3.3.5-20050130 (Gentoo 3.3.5.20050130-r1, ssp-3.3.5.20050130-1, pie-8.7.7.1)) #2 Sun Aug 7 17:25:30 GMT 2005
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0400 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000003febc00 (usable)
 BIOS-e820: 0000000003febc00 - 0000000003ff0000 (ACPI data)
 BIOS-e820: 0000000003ff0000 - 0000000004000000 (ACPI NVS)
 BIOS-e820: 00000000ffff0400 - 0000000100000000 (reserved)
63MB LOWMEM available.
On node 0 totalpages: 16363
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 12267 pages, LIFO batch:2
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.1 present.
Allocating PCI resources starting at 04000000 (gap: 04000000:fbff0400)
Built 1 zonelists
Kernel command line: root=/dev/hda3
No local APIC present or hardware disabled
mapped APIC to ffffd000 (01081000)
Initializing CPU#0
PID hash table entries: 256 (order: 8, 4096 bytes)
Detected 233.903 MHz processor.
Using tsc for high-res timesource
Speakup v-2.00 CVS: Wed Mar 2 20:22:02 EST 2005 : initialized
Speakup:  loading module "speakup_n"
request_module: runaway loop modprobe speakup_n
Console: colour VGA+ 80x25
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 60704k/65452k available (2305k kernel code, 4288k reserved, 951k data, 172k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 461.82 BogoMIPS (lpj=230912)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Couldn't initialize miscdevice /dev/synth.
CPU: After generic identify, caps: 008001bf 00000000 00000000 00000000 00000000 00000000 00000000
CPU: After vendor identify, caps: 008001bf 00000000 00000000 00000000 00000000 00000000 00000000
Intel Pentium with F0 0F bug - workaround enabled.
CPU: After all inits, caps: 008001bf 00000000 00000000 00000000 00000000 00000000 00000000
CPU: Intel Mobile Pentium MMX stepping 01
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfda20, last bus=2
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
Linux Plug and Play Support v0.97 (c) Adam Belay
SCSI subsystem initialized
Linux Kernel Card Services
  options:  [pci] [cardbus] [pm]
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Using IRQ router PIIX/ICH [8086/7110] at 0000:00:01.0
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16ac)
inotify device minor=63
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
Initializing Cryptographic API
Limiting direct PCI/PCI transfers.
Real Time Clock Driver v1.12
Non-volatile memory driver v1.2
PCI: No IRQ known for interrupt pin A of device 0000:00:14.0. Please try using pci=biosirq.
neofb: mapped io at c4880000
Autodetected internal display
Panel is a 800x600 color dual scan display
neofb: mapped framebuffer at c4b00000
neofb v0.4.2: 2048kB VRAM, using 800x600, 37.878kHz, 60Hz
Console: switching to colour frame buffer device 100x37
fb0: MagicGraph 128XD frame buffer device
vesafb: NeoMagic, MagicGraph 128XV, 01.0 (OEM: MagicGraph 128XD 40K SVGA BIOS)
vesafb: VBE version: 2.0
vesafb: protected mode interface info at c000:8d80
vesafb: pmi: set display start = c00c8db6, set palette = c00c8e08
vesafb: monitor limits: vf = 0 Hz, hf = 0 kHz, clk = 0 MHz
vesafb: scrolling: redraw
vesafb: cannot reserve video memory at 0xfd000000
vesafb: framebuffer at 0xfd000000, mapped to 0xc4d80000, using 937k, total 1920k
fb1: VESA VGA frame buffer device
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled
ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]
mice: PS/2 mouse device common for all mice
ts: Compaq touchscreen protocol output
input: AT Translated Set 2 keyboard on isa0060/serio0
input: PS/2 Generic Mouse on isa0060/serio1
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
FDC 0 is a post-1991 82077
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 0000:00:01.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xf4f0-0xf4f7, BIOS settings: hda:DMA, hdb:pio
Probing IDE interface ide0...
hda: TOSHIBA MK6014MAP, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
Probing IDE interface ide2...
Probing IDE interface ide3...
Probing IDE interface ide4...
Probing IDE interface ide5...
hda: max request size: 128KiB
hda: 11733120 sectors (6007 MB), CHS=12416/15/63, UDMA(33)
hda: cache flushes not supported
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4
PCI: Found IRQ 9 for device 0000:00:13.0
Yenta: CardBus bridge found at 0000:00:13.0 [10cf:1036]
Yenta: Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:13.0, mfunc 0x01cc1d22, devctl 0x46
Yenta: ISA IRQ mask 0x0c98, PCI irq 9
Socket status: 30000006
PCI: Found IRQ 9 for device 0000:00:13.1
Yenta: CardBus bridge found at 0000:00:13.1 [10cf:1036]
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:13.1, mfunc 0x01cc1d22, devctl 0x46
Yenta: ISA IRQ mask 0x0c98, PCI irq 9
Socket status: 30000020
i2c /dev entries driver
piix4_smbus 0000:00:01.3: Found 0000:00:01.3 device
Advanced Linux Sound Architecture Driver Version 1.0.8 (Thu Jan 13 09:39:32 2005 UTC).
ALSA device list:
  No soundcards found.
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
NET: Registered protocol family 1
NET: Registered protocol family 17
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: hda3: orphan cleanup on readonly fs
ext3_orphan_cleanup: deleting unreferenced inode 282409
ext3_orphan_cleanup: deleting unreferenced inode 282408
EXT3-fs: hda3: 2 orphan inodes deleted
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 172k freed
Adding 500368k swap on /dev/hda2.  Priority:-1 extents:1
EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
EXT3 FS on hda3, internal journal
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
kjournald starting.  Commit interval 5 seconds
EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
EXT3 FS on hda4, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
cs: IO port probe 0xc00-0xcff: clean.
cs: IO port probe 0xc00-0xcff: clean.
cs: IO port probe 0x800-0x8ff: excluding 0x800-0x807
cs: IO port probe 0x800-0x8ff: excluding 0x800-0x807
cs: IO port probe 0x100-0x4ff: excluding 0x220-0x22f 0x388-0x38f 0x4d0-0x4d7
cs: IO port probe 0x100-0x4ff: excluding 0x220-0x22f 0x388-0x38f 0x4d0-0x4d7
cs: IO port probe 0xa00-0xaff: clean.
cs: IO port probe 0xa00-0xaff: clean.
Loaded prism54 driver, version 1.2
PCI: Enabling device 0000:05:00.0 (0000 -> 0002)
eth0: resetting device...
eth0: uploading firmware...
eth0: firmware version: 1.0.4.3
eth0: firmware upload complete
spurious 8259A interrupt: IRQ7.
eth0: interface reset complete
eth0: prism54_set_txpower() auto power will be implemented later.

Quellcode

0000:00:00.0 Host bridge: Intel Corporation 430TX - 82439TX MTXC (rev 01)
0000:00:01.0 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 02)
0000:00:01.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
0000:00:01.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01)
0000:00:01.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 02)
0000:00:13.0 CardBus bridge: Texas Instruments PCI1221
0000:00:13.1 CardBus bridge: Texas Instruments PCI1221
0000:00:14.0 VGA compatible controller: Neomagic Corporation NM2160 [MagicGraph 128XD] (rev 01)
0000:05:00.0 Network controller: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01)